Replace apt-get command by apt

This commit is contained in:
Romain Bazile 2020-07-20 23:23:30 +02:00
parent 3738ba3cd9
commit 493915c7b4

View file

@ -46,9 +46,9 @@ Make sure you have access to internet and update/upgrade your fresh Raspbian ins
Update your Pi first. Open up a terminal, and do the following: Update your Pi first. Open up a terminal, and do the following:
```sh ```sh
sudo apt-get update -y sudo apt update -y
sudo apt-get upgrade -y sudo apt upgrade -y
sudo apt-get install git sudo apt install git
``` ```
You can now reboot your Pi safely. You can now reboot your Pi safely.
@ -108,7 +108,7 @@ You can also connect to your PlanktoScop by using ssh using `ssh pi@planktoscope
You can then run the following to make sure your Raspberry has the necessary components to install and build everything it needs and to create the necessary folders: You can then run the following to make sure your Raspberry has the necessary components to install and build everything it needs and to create the necessary folders:
```sh ```sh
sudo apt-get install build-essential python3 python3-pip sudo apt install build-essential python3 python3-pip
mkdir test libraries mkdir test libraries
``` ```
@ -199,7 +199,7 @@ You can start by testing that the GPS module is working. Either install your Pla
Now you need to run the following: Now you need to run the following:
```sh ```sh
sudo apt-get install gpsd gpsd-clients sudo apt install gpsd gpsd-clients
stty -F /dev/serial0 raw 9600 cs8 clocal -cstopb stty -F /dev/serial0 raw 9600 cs8 clocal -cstopb
cat /dev/serial0 cat /dev/serial0
``` ```
@ -304,7 +304,7 @@ sudo systemctl restart nodered.service
In order to send and receive data from Node-RED, you need to install this. Run the following: In order to send and receive data from Node-RED, you need to install this. Run the following:
``` ```
sudo apt-get install mosquitto mosquitto-clients sudo apt install mosquitto mosquitto-clients
``` ```
@ -348,7 +348,7 @@ More detailed information can be found on this [website](https://www.pyimagesear
MorphoCut is packaged on PyPI and can be installed with pip: MorphoCut is packaged on PyPI and can be installed with pip:
```sh ```sh
sudo apt-get install python3-scipy sudo apt install python3-scipy
pip3 install -U git+https://github.com/morphocut/morphocut.git pip3 install -U git+https://github.com/morphocut/morphocut.git
``` ```
@ -371,8 +371,8 @@ The MorphoCut documentation can be found [on this page](https://morphocut.readth
Make sure to update your Pi Make sure to update your Pi
``` ```
sudo apt-get update -y sudo apt update -y
sudo apt-get full-upgrade -y sudo apt full-upgrade -y
``` ```
Reboot your Pi safely Reboot your Pi safely