Docs: add proper info about the LED wiring

This commit is contained in:
Romain Bazile 2021-03-10 19:58:43 +01:00
parent 2ff1df427b
commit 71bc0e6a1e
2 changed files with 6 additions and 0 deletions

View file

@ -94,6 +94,12 @@ You can mount the camera using the appropriate holes on the camera mount **G**.
The LED can then be wired up and put into its mount **F**. If you wire the LED yourself, remember to give enough length to reach the motor driver on the other end of the microscope. You can also add a bit of glue to fix **F** to the motor mount **E** at this time to make assembly easier, though it is not required. The LED can then be wired up and put into its mount **F**. If you wire the LED yourself, remember to give enough length to reach the motor driver on the other end of the microscope. You can also add a bit of glue to fix **F** to the motor mount **E** at this time to make assembly easier, though it is not required.
!!! warning
![Led](assembly_guide/render/led.webp)
This picture shows the correct wiring for the LED. Please make sure the red wire is on the long pin of the LED.
## Step 10: Vertical slices assembly ## Step 10: Vertical slices assembly
You can now start placing the motor mount/LED assembly- **B**, You can now start placing the motor mount/LED assembly- **B**,
![Step5](assembly_guide/render/step5.webp) ![Step5](assembly_guide/render/step5.webp)

Binary file not shown.

After

Width:  |  Height:  |  Size: 8.3 KiB