doc: fix overclock info
This commit is contained in:
parent
6cb8b70eaa
commit
f2587876cb
|
@ -91,16 +91,13 @@ Also, to be able to use the ISO8601 datetime standard, we need to change the loc
|
|||
These steps can also be done from the Raspberry Pi Configuration GUI tool that you can find in `Main Menu > Preferences`. Go to the `Interfaces` tab. Pay attention, here the Serial Port must be enabled, but the Serial Port Console must be disabled.
|
||||
|
||||
!!! tip
|
||||
Special optionnal step: overclocking
|
||||
|
||||
We are first going to make sure that your PlanktoScope receives proper PPS signal. We need to add the following line at the end of `/boot/config.txt`. Open the file with `sudo nano /boot/config.txt` and add the following at the end:
|
||||
|
||||
```
|
||||
# Pi overclock
|
||||
over_voltage=6
|
||||
arm_freq=2000
|
||||
```
|
||||
Optional step: overclocking
|
||||
It's possible to overclock the machine and get a bit more performance out of it. Open `/boot/config.txt` with `sudo nano /boot/config.txt` and add at the end of the file on two new lines:
|
||||
|
||||
`over_voltage=6`
|
||||
|
||||
`arm_freq=2000`
|
||||
|
||||
Those settings were verified to be stable, but if you notice any weird behavior under a high load, remove those lines.
|
||||
|
||||
|
||||
|
|
Loading…
Reference in a new issue