From fd0f0e42690243dfb3cdb9175296a19ab7253903 Mon Sep 17 00:00:00 2001 From: Romain Bazile Date: Sun, 19 Jul 2020 19:22:32 +0200 Subject: [PATCH] Add type to code lines --- README.md | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) diff --git a/README.md b/README.md index a8f990a..9b39f4d 100644 --- a/README.md +++ b/README.md @@ -45,13 +45,13 @@ The first boot to the desktop may take up to 120 seconds. This is normal and is Make sure you have access to internet and update/upgrade your fresh Raspbian install. Update your Pi first. Open up a terminal, and do the following: -``` +```sh sudo apt-get update -y sudo apt-get upgrade -y ``` You can now reboot your Pi safely. -``` +```sh sudo reboot now ``` @@ -60,7 +60,7 @@ sudo reboot now ### Enable Camera/SSH/I2C in raspi-config Open up a terminal once again, and access the configuration tool: -``` +```sh sudo raspi-config ``` @@ -79,7 +79,7 @@ This time, choose `No` to deactivate the login shell on the serial connection, b These steps can also be done from the Raspberry Pi Configuration GUI tool that you can find in `Main Menu > Preferences`. Go to the `Interfaces` tab. Pay attention, here the Serial Port must be enabled, but the Serial Port Console must be disabled. Reboot your Pi safely. -``` +```sh sudo reboot now ``` @@ -89,7 +89,7 @@ sudo reboot now Start by following [Adafruit's guide](https://learn.adafruit.com/circuitpython-on-raspberrypi-linux/installing-circuitpython-on-raspberry-pi). You can start at the chapter `Install Python Libraries`. For the record, the command are as following, however, Adafruit's page might have been updated, so please make sure this is still needed: -``` +```sh pip3 install RPI.GPIO pip3 install adafruit-blinka sudo pip3 install adafruit-circuitpython-motorkit @@ -100,7 +100,7 @@ sudo pip3 install adafruit-circuitpython-motorkit You can find more information about the RPi Cam Web Interface on [eLinux' website](https://elinux.org/RPi-Cam-Web-Interface). To set it up, clone the code from Github and enable and run the install script with the following commands -``` +```sh git clone https://github.com/silvanmelchior/RPi_Cam_Web_Interface.git cd RPi_Cam_Web_Interface ./install.sh @@ -158,7 +158,7 @@ node-red-pi --max-old-space-size=256 #### Autostart on boot Run Node-RED when the Pi is turned on, or re-booted, enable the service to autostart by running the command: -``` +```sh sudo systemctl enable nodered.service ```