# Chapter 10 ## Notes | Topic | Description | | --------- | ----------- | | **Time** | | | **Tools** | | | **Parts** | | ## Mount the **Raspberry Pi Camera HQ** on **Part B** 🟣 Locate the 4 holes on the top of the **Part B**. --- πŸ”΅ **A2**. Standoff M2.5 - 15mm - Brass --- Insert the four **Standoff M2.5 - 15mm**. --- The result should be similar to the picture. --- 🟒 **B4**. Wrenches for standoffs --- Using the small side of the **Standoff Wrench**, secure the **4 M2.5 - 15mm Standoffs** --- * βœ… Make sure to screw until the **Standoff** is properly tightened into the hole. * ❌ Do not stop screwing before. --- σ°”ž Locate the **Raspberry Pi Camera HQ** --- Remove the lens cap **Raspberry Pi Camera HQ**. --- !!! warning ⚠ Make sure your camera lens is clean. If it is not, gently wipe using cotton swab for this task. --- Place the **Raspberry Pi Camera HQ** on top of the four **Standoffs** installed on **Part B**. 🟣Ensure correct orientation of the **Raspberry Pi Camera HQ**. The **black connector** where the **Ribbon Cable** was removed is on the same side as the 🟒slot circled in green --- 🟠 **A4**. Screw M2.5X5mm CHC - SS --- 🟑 **B3**. Allen key 2mm --- Use the allen key and tighten the **Raspberry Pi Camera** to the **Standoffs**. --- The result should be similar to the picture. !!! info 🎬 Store this assembly for later.