planktoscope/docs/hardware/chapter_10.md
2022-12-19 02:25:34 +01:00

1.4 KiB

Chapter 10

Notes

Topic Description
Time
Tools
Parts

Mount the Raspberry Pi Camera HQ on Part B

🟣 Locate the 4 holes on the top of the Part B.


🔵 A2. Standoff M2.5 - 15mm - Brass


Insert the four Standoff M2.5 - 15mm.


The result should be similar to the picture.


🟢 B4. Wrenches for standoffs


Using the small side of the Standoff Wrench, secure the 4 M2.5 - 15mm Standoffs


  • Make sure to screw until the Standoff is properly tightened into the hole.
  • Do not stop screwing before.

󰔞 Locate the Raspberry Pi Camera HQ


Remove the lens cap Raspberry Pi Camera HQ.


!!! warning

⚠ Make sure your camera lens is clean. If it is not, gently wipe using cotton swab for this task.

Place the Raspberry Pi Camera HQ on top of the four Standoffs installed on Part B.

🟣Ensure correct orientation of the Raspberry Pi Camera HQ. The black connector where the Ribbon Cable was removed is on the same side as the 🟢slot circled in green


🟠 A4. Screw M2.5X5mm CHC - SS


🟡 B3. Allen key 2mm


Use the allen key and tighten the Raspberry Pi Camera to the Standoffs.


The result should be similar to the picture.

!!! info

🎬 Store this assembly for later.